Recent content by CENTEX

Just Google that Parr number? I'd assume there are other generics that may work as well. Thanks for sending.

Looks like what I need.

That's excellent news! So keep the bulbs 24V and just utilize a 12V fj40 flasher circuit?

Anyone have one? TIA!

***UPDATE*** In case anyone runs into this, I ordered these from Amazon. THEY ARE PLUG AND PLAY IN MY PJ77!! Mazke certain to use the included CAN-BUS adapters included. Hi beam indicator does not work on dash, but the lights work on both hi and lo beam perfectly...

What I think I need to do is intercept the wires from the hi/low switch and devise my own relay / wiring network.

Wish I had better news, but so far this fix didn't work. These lights shipped with a CAN bus adapter, so tomorrow I am going to try to wire in without the adapter. When I plugged directly in (without any modifications), the high beams came on. When I plugged in without, nothing at all worked.

BJ74PE, THANK YOU FOR SENDING THIS! I will try later today, as I have ordered a few of the 24v 5 pin relays.

Hello, I tried resistors, and they didn't help.

So I guess I could run a couple of 5 pole relays wired to +24V to 85 & 30, and the ground for each beam setting to pin 86, then through to the corresponding hot wire on the led headlight coming off 87?

@elk - so on my 70 series the ground floats depending on hi or low beam?

Pics would be great. I've been beating my head against a wall all day. Thanks!

H6024

I installed these: Off-Road LED Work Light/LED Driving Light - 7" Round - 40W - 1,600 Lumens | Super Bright LEDs

Did you ever figure anything out? I've got an issue where high beams do not work, only low beams. I've tried polarity swaps, resistors, etc. and am stuck!