Will do!! The rear bed floor is still in the original shipping container so, it can be shipped. The other parts are in shrink wrap on a pallet and can be shipped the quarter panels are the only tricky ones to ship because of shape. I’ll send you pics to your cell phone. Thanks.
I’ve got everything you need to rebuild one. Complete HFS floor with supports, quarters, wheel wells and rear channels from CCOC. I’m in SW Pennsylvania.
My son bought me 1/2 tub and so I no longer need these sheetmetal parts listed below in attached PDF file. They are new condition with a little flash rust here and there but overall have been stored in my garage and in perfect condition. Quarters and bed wheel wells, corner channels have been...
If I understand correctly and you’re looking for a used OE Set, I still have my original covers, removed now in a box from my 79/2 40. They’re better than the ones in the pic. I’ve decided to replace them but at one point I considered putting them back on.
Thank you for sharing! Only thing this instruction is missing, is the torque required for the air injector nozzle “The fitting that screws into the head”. This looks like the torque value for the compression fittings. Those fittings are attached to the air rail and screw onto the top of each air...
Good question!! Been trying to find out for awhile now. Nothing in the FAQ I could find. Is that antiseize around the injectors? Was tempted to do that to but with the temperature I decided not too.
Yep. I found a pic of my original made from cloth asbestos fiber. Also, the replacement version in steel. See below. If there was a way to verify that at least the 3 piece manifold horn would fit the curve of your 75-6 cali version. That would be a start. Then modifying the other bolt hole location.