Recent content by CamCald85

  1. C

    1hz custome coolingguy

    Now for the second heat exchanger the heater feed line is 3/4 of an inch to elinanate constant flow on a cold morning a second thermostat may well serve as a good auto solution to control water movement the average thermostat when fully open has a opening of approx 12 mill with that math how...
  2. C

    1hz custome coolingguy

    Yes that was the idear of the bonnet chocks to give more room for the air to escape you think I should remove the rubber inner guard flaps
  3. C

    1hz custome coolingguy

    Yes that was the idear of the bonnet chocks to give more room for the air to escape you think I should remove the rubber inner guard flaps
  4. C

    1hz custome coolingguy

    Yes the idear of lifting the bonnet at the back was to encourage air flow by letting hot air out used to do this to nissans with good results
  5. C

    1hz custome coolingguy

    Ok removed bonnet risers. Can't remove thermostat fully or even cut the guts out due to the bypass system. Already had a look under mine and at 50 mill longer would b stupid close to steering dampner how ever after enough digging have worked out that the Bottom spout on the 79 rad comes out...
  6. C

    1hz custome coolingguy

    Ok removed bonnet risers. Can't remove thermostat fully or even cut the guts out due to the bypass system. Already had a look under mine and at 50 mill longer would b stupid close to steering dampner how ever after enough digging have worked out that the Bottom spout on the 79 rad comes out...
  7. C

    1hz custome coolingguy

    Yes the eng is to tight still I can feel it was terrible on 1st start up,is getting better though compression is a tad high which will push temp a tad my bar is very similar to the one shown except 3 mill steel with the bumper arear bigger to accomodate winch very good advise on air flow already...
  8. C

    1hz custome coolingguy

    RAM AIR is the problem people for those of u who don't know air flow is 1/3 of your cooling at speeds over 80 klmh the fan almost becomes irrelevant and you become reliant on ram air ITS NOT THE FAN HUB a bigger radiater means more capacity goin go down the dimple tube road thus slowing the...
  9. C

    1hz custome coolingguy

    Yea in hindsight I should have put a 1hdft in hard to come buy and very expensive approx 10k for a second handy then u have to rebuild it spent 8 k on 1hz internals and should give me close to a million Kay's it not heavy modified just a really well built good Pistons rings rods blue printed and...
  10. C

    1hz custome coolingguy

    Not turboed yet built 4 one though exhaust is 2 .5 inch guys read the post fan hub is new and pulled down and refilled with Toyota fluid pulling hard 5 post bull bar with big mesh like I said ram air is the problem spotties out atm 2 increase air flow not enough though and at $7,000 for the bar...
  11. C

    1hz custome coolingguy

    Hello all my name is Cameron 1st time on here. I've joined up because i need some help. Here is the scenario 1 have a hzj75 series that I stripped to the chassy and completely overhauled ground up ( when my parter gets home I'll get her 2 show me how to put up pics ) I am a mechanic by trade...
Back
Top Bottom