Recent content by Cabinetman

  1. C

    Any buyer's remorse after getting the new 250?

    This thread got interesting. I do appreciate those of you that gave your first hand impressions of the Land Cruiser (Prado?) 250. I know this is going to be a different vehicle than the 200 I owned or the full-size trucks and SUVs I've been driving for the last couple of decades. I do wish...
  2. C

    Any buyer's remorse after getting the new 250?

    I'm in the early stages of figuring out what I plan to buy next year to replace my 2022 GMC Sierra 1500 AT4X. I think I'm ready to move into something smaller, but still has some off-road credibility. I have owned Toyotas in the past including a '13 LC200, '19 4Runner, and a '20 Tundra...
  3. C

    My new 200

    Looks really good. Congrats!
  4. C

    Resonance in the steering wheel of my new 2014 LC

    I have also been paying very close attention to my buzzing issue to see if I can draw any parallels besides the RPM range that it occurs. So far I have noticed that the issue is less noticeable when the drivetrain is not fully warmed up. My commute starts with 5 miles of side street driving...
  5. C

    Need a rubber mat for the way back of my 2008 LC

    I have the same set up as well. I didn't cut out the holes to allow the third row to be used with the Weathertech cargo mat in place. I just roll it up or take it out in the rare situation I actually use the third row.
  6. C

    Official 200 Series Chat and BS Thread

    I had only seen one 200 in the Fort Worth, TX area since I bought mine a couple of months ago until this week. I have seen 5 in the last two days including a 200 with a lift, bumpers and a roof rack on I30 near downtown yesterday.
  7. C

    Backing up mirrors setting.. not working

    It is funny that this thread turned into a Wilson discussion as I just got word last week my latest CQB was ready. I sent my check off on Friday to my dealer and should have the pistol next week.
  8. C

    TSB for steering wheel vibration - LC & LX differences

    Even though this TSB only applies to '08 and '09 year models I have the same vibration as described in the TSB in my '14. I had thought it was caused by exhaust resonance, but this thread has me thinking otherwise. I had been debating even bringing up my issue to the dealer due to past...
  9. C

    Interior LEDs

    Properly engineered LEDs should dissipate heat pretty well and not get hot enough to melt the fixture. I have yet to have an issue in the 4 vehicles I have owned with aftermarket LED interior lights.
  10. C

    Interior LEDs

    In my experience they give you a much better lit interior. My LC200 with black leather was poorly lit with the OEM bulbs. Now the lighting is considerably better. They also draw less current and should never burn out. The only downside I have found so far is when someone turns on an interior...
  11. C

    Interior LEDs

    No problem. Glad I could help. Regarding installation, it is all pretty straight forward but I did figure a few things out by trial and error. The rear dome light and the lights on either side of the video screen (second row map and dome lights) just pop off using a wide flat blade in the...
  12. C

    Interior LEDs

    You really don't need to buy a kit. I went with VLEDS and I will link what I used below. For the front map lights, second row dome lights and second row map lights I used these bulbs (3 pair): http://www.vleds.com/shop-bulb-numbers/194-168-158-led/6-5k.html For the courtesy lights in the...
  13. C

    What have you done to your 200 Series this week?

    I actually went with the P metric tire over the LT to save unsprung weight. This is my daily driver that sees some ranch roads and such, but no serious off-roading at this point.
  14. C

    What have you done to your 200 Series this week?

    So far I like the Nittos, but I only have about 50 miles on them so far. There is a little more road noise than the OEM Bridgestones, but not much. I will update once I get some more miles on them.
  15. C

    What have you done to your 200 Series this week?

    I added some Nitto Terra Grappler G2s in the OEM size.
Back
Top Bottom