Recent content by BVV4

In my car, I used this utility to enter arbitrary values greater or less than 300 millimeters and corrected the incorrect rear sensor reading from -12 millimeters to 0. This didn't work with the front sensors. I don't understand the calibration algorithm.

Who knows what this utility is for?

I think I've found a solution to the problem of the rear sensor reading being - 11 mm . The AHC control unit has three groups of height sensor values. They are all listed in the TechStream software in the lower right corner. The altitude sensor values that everyone is guided by (in the upper...

It raises the wheel to 51 centimeters, but the sensor shows -11. It doesn't raise mine to 0 centimeters according to the sensor, or 52 centimeters from the hub to the fender. So, we probably have different problems.

Yesterday the pressure was 6.9 and 6.2, today for some reason it's 6.6 and 6.0. Measuring the pressure with the temperature sensor disconnected fails, resulting in error C1762.

My current zero sensor setting is 52 centimeters from the fender. But the rear of the car doesn't rise to zero. It rises to 51 centimeters, and the sensor reading is -11. If I readjust the zero sensor setting to 51 centimeters, the rear of the car drops to 50 centimeters, and the sensor reading...

I have the same problem with the rear suspension: it's always stuck at -10-12 mm, while the front sensors are reading 0. The rear sensor readings correspond to the actual height, meaning the distance from the center of the hub to the fender (48-51 cm) is 10-12 mm less than it should be. If I...