Recent content by bswindle

Well I'm figuring this forum out and will start posting my progress

This is my installing tool made from exhaust flanges

On my fj40 1979 Will I have to cut the crossmember under the transmission to fit everything back in? I saw a neat setup in speedway motors to build one if I need to?

So the tool (me) built a tool i didn't need It's all good will let you know how it goes

Thanks!! That looks a lot easier

Sorry floating not footing

When you used the the snap ring pliers are you footing the od unit out the back just a bit to get the ring on and then tightening the od unit up to the transfer case? I was just test fitting it that seems to work?

The fastenal clip is the M54 Part number 11506617

I built an installing tool using 2" IDx2"od exhaust fitting Then 2.25 od exhaust fitting for the slide Lots of grinding I'm going to try using a lathe to see if I can make it better Mine should work but it's really backward

Found the clip at fasten all Time to start putting it together

thanks the retaining clip is the big one on the main input gear and the tool for that it is a two piece one one holds the clip in place then you slide od unit in the transfer case then slide the outer part of the tool in and push the clip on the shaft and hold the gear in place.

Does anyone know where I can find the installing tool for the Fairey overdrive, or the dimensions to build one? and does anyone have a part number for the retainer cilp?

Thanks! good information won't help me much with mine. your's seems to be a better design than mine.

Mark, thanks for your help I have the right transfer case now, do you have a number for the retainer clip for the overdrive, and where i could find the install tool or sizes to build one, I have one I have built and have not used it yet just looking

Mark do you know where I can get the retainer clip for the overdrive, and get the install tool?