Recent content by Bruce123

Ill give that a shot thanks! Sadly no, my moms would definitely kick me out the house at that point. Ill give that a go. Thank you!

Doing the passenger side Knuckle Rebuild on my stock 1995 today when I stripped a steering knuckle stud. I have a set of spare studs but I am unsure how to remove the old stud. I cant double nut and I have tried vice grips but no luck. Does anyone have any advice for this or am I better of...

Stud on the left was the one I replaced. The only major differences is the newer stud doesn't have that raised dimple at the top.

Yep I can do that. Plan to do it this weekend, Ill keep you posted

Yep, New one supersedes the old one part no. Thanks for the help guys!

Broke a front wheel stud on Sunday. Toyota Dealer today gave me Part No. 90942-02082 for the front studs. I have read that this has replaced the old Part No. 90942-02049. Does anyone have any experience with these new studs? Or should I request the old one?

Last November, I was dealing with a limp mode problem in my 95 fzj80. It would reach about 20 mph and peak at 2k rpm and would stall going up hill. I parked it for a few months and thought it was a fuel issue. Got a new fuel pump and installed it in January. Drove it around for a while and...

Yep that did the trick. Didnt even know they could do that, Thanks alot!

Hey everyone, I finally got around to replacing the gears in the power seats of my 95 cruiser. The trim that you are supposed to remove to access the motor is blocked by the seat. Every video I have seen doesnt have this extra piece. Any advice on removing the trim would be greatly appreciated!

Hey everyone, I have been fixing up a 1995 that I inherited from my family. One of the issues is a low idle when the engine is warmed up (Around 200-300rpm). It also drops revs when turning the wheel. This morning I got the P0510 code so I am planning on removing the throttle body, cleaning...