Recent content by BReynolds

  1. B

    Hoping to get input for work being done on 2003 lx470 in distress.

    I’ve built engines and can turn wrenches but and am at their mercy.
  2. B

    Hoping to get input for work being done on 2003 lx470 in distress.

    They aren’t doing cam or crank seals. That’s what’s so bad in my opinion. Thanks for your input.
  3. B

    Hoping to get input for work being done on 2003 lx470 in distress.

    I’m driving across country and had the water pump bracket fail and pretty much left me stranded at the local Toyota dealership. They’re charging $1750 for the water pump bracket alone with labor and want $2250 to include the timing belt along with a new drive belt. I know this is grossly...
  4. B

    Stolen Catalytic Converter LC100

    Gonna have a metal plate fabricated to protect them from thieves.
  5. B

    Engine knock at cold start

    I don't think so but can't say for sure. The sound pretty much went away after I did the service I described above. I've built engines for muscle cars over the years and am somewhat mechanically inclined. With that being said, I'd like to see better oil pressure as at idle its a hair under the...
  6. B

    Engine knock at cold start

    I changed plugs, did a BG's EPR engine flush with the MOA additive and noise has pretty much stopped. Not sure exactly what it was but think the MOA helped a lot.
  7. B

    Brake Booster Install.

    It is a 2003. The shop that I went to already over filled the New master cylinder and figured i'd try to finish it instead of taking it back to them. Thank you for the reply as I will try that today.
  8. B

    Brake Booster Install.

    I cannot believe that I didn't notice that. It looked like a short piece of wire that was bent to use as a pin to hold the pedal. Maybe its time for me to get some glasses.
  9. B

    Brake Booster Install.

    I just had the master cylinder replaced by a local shop and now the LX pulls a little to the right when braking. I'm assuming that there's air in the lines and was curious if It's best to bleed the lines at the master cylinder as well as wheels. TIA
  10. B

    RTH: Brake booster leaking — Can it be rebuilt?

    I just noticed that the booster reservoir seems to be loose and rocks back and forth. Maybe the grommets are leaking from too much play? Wasn't sure if its supposed to have play in it..
  11. B

    Looking for some Technical opinions and would be much appreciated.

    It's definitely not a tick. A small knock for a second or two then clears up. I've driven it for a while at different intervals and no noise at all. Only morning startups when it's cold. The oil pressure is usually at a quarter at idle and goes up a little when tach goes up. I just ordered over...
  12. B

    Looking for some Technical opinions and would be much appreciated.

    I didn't even know about Blackstone. Thank you for mentioning them as I just looked them up.
  13. B

    Looking for some Technical opinions and would be much appreciated.

    I recently purchased a 2003 lx 470 which has an engine knock at cold start. It lasts about 1-2 seconds then goes away. I’m guessing it could be bearings from bad maintenance or maybe old spark plugs.. or maybe even a bad injector. It has 143k and don’t know if it has the original plugs. I just...
  14. B

    Engine knock at cold start

    It is new to me. I didn't get to cold start it before purchase. I changed the oil filter this evening and will see what it does in the morning.
  15. B

    Engine knock at cold start

    I changed oil last week and used a wix filter. Gonna get a Toyota filter and see what happens. Thanks!
Back
Top Bottom