I've been scouring the internet for replacement hardware and haven't found anything with the correct thread pitch. Would rather not re-tap the wheels to a more standard size if I can help it.
If the shop ends up figuring out custom collars I may be interested in picking some up too.
I ended up buying a brand new KDSS bar to fix the problem, but it is only a matter of time before the glue fails on the oem rubber clamps again.
I do have these bumpstops on the back (came with the lift kit) Progressive Bump Stop Kit - https://www.peaksuspension.com/products/progressive-bump-stop-kit and Durobumps on the front. Going from the OEM bumpstops to the Durobumps made a big difference. Will have to see if I need something more...
The Firestone bags (4.75"x10") didn't end up fitting into the Eibach rear load-leveling setup. The springs are smaller I.D. at 3.75" compared to standard lift springs. After some research it was recommended I pick up some Airlift 60910 (4.0" X 9.0"). My other project vehicle has been down for...
Updates: I recently added a few cosmetic mods, installed Durobumps in front and a set of recovery points. I have been having fun with the Seattle Avants Offroad group and their offroad course over by the Dirtfish Rally school. Thanks to some of the club members that volunteered as...
I don't think the axle needed much centering with lift height I am at in the rear - around 3". The track bar length looks pretty close to stock when I eyeballed them next to each other under the truck. It definitely gives some extra clearance around the KDSS ram and link however. I tried to get...
It has been working out great so far. I took it out on the Avants Offroad course next to Dirtfish Rally School and had no issues.
Got a few battle scars on the rear bumper driving over a new obstacle they added!
Just to update you I got all my lift parts installed, notably the PCK, all three Treaty Oak KDSS spacers, and the Ironman KDSS Panhard bar with no fitment issues. Check out my build thread for a pic!
Quick update - Thanks to John @ Auburn Car Repair & Offroad for the install of the lift parts and brake upgrade.
We ran into an issue where the Firestone Coil-Rite bags I grabbed didn't fit the Eibach rear springs for this kit, but am going to try to find a set that will work.
I can confirm...