Quick update just in case anyone else ever has the same issue and stumbles across this. The problem was user caused. The little Z bracket that bolts to the shaft has a specific orientation. If it's spun 180 degrees on the shaft, the longer edge faces towards the fuel pump body, which then...
I'm away from the truck until next week but planning on working on it by myself when I'm back. I want to turn the engine over while watching the pump operation. On motorcycles we normally run a jumper lead from the positive battery terminal directly to the positive terminal on the starter motor...
Thanks for the heads up mate. The mechanic that sold it to me mentioned the same thing so I was careful to make sure it went in the right way and and was seated properly before tightening everything up.
just checked the fuel at the injectors. bled the IP at the nut on the side of it first and had no signs of air there then undid the first two injector fittings (from the front of the engine) until they were loose enough to turn by hand and not much more than a dribble of fuel coming out with the...
the big spring and all the shims wend back in in the same order they came out in. isnt it called the diaphragm cover though? i didnt touch the governor housing cover (at least i dont think i did)
Edit: my mistake. ive got the FSM here now so will get the terminology right from here on in.
the fuel screw im not too sure about. i had read elsewhere that others had issues with it after changing the diaphragm but didnt want to mess with it before understanding its operation and potentially making things worse.
i havent checked if theres fuel at the in injectors but will do it later...
After the HJ47 started idling at ridiculously high rpm and blowing smoke on deceleration, i pulled the old diaphragm out and found the leather was all torn up. replaced it with the correct Denso part and now the motor wont fire at all.
i pulled the diaphragm a second time to make sure i hadnt...
thanks for the response mate. is there a set range of measurements that would work for the 47 that i can look up without pulling the existing leaves off?
Hi all, ive just recently bought myself a 1985 HJ47. it sat for 3 years before i bought it and because im in the tropics, anything made of rubber has morphed into half-set glue. so while replacing wheel cylinders the other day, i noticed that the suspension leaves are in need of replacement...