Many times and have replaced the battery 2 times - not a battery charge issue. I believe it is either one or a combination of 1. not enough voltage getting to the starter (deteriorated wiring between battery and + on starter); 2. the starter solenoid intermittently going bad; 3. the ignition...
I purchased two as a minimum order and have installed one on my '92 FJ80. I discarded the factory lighting and installed LED's. The unit comes with rectangular face-mount lighting. It is a very heavy gauge steel with a black powder coat finish. Installation requires a slight amount of...
Hey all, I'm an admitted amateur on the electrical system for the 92 FJ80 with the 3FE motor and I'm wondering if there is an alternative for the distributor points such as the Pertronix Ignitor that is advertised for the 2F and 3F motors. My research has found nothing. I assume it has...
This is the BEST tutorial for fixing that pesky non functioning high beam issue. I couldn't find a used Corolla switch, but was able to source a new OEM Toyota Corolla part for much less than a dealership wanted for the identical LC part. Job took about an hour and was definitely a 1 banana...
Yes, it moves with the CDL disengaged and with the hubs disengaged. I just redid the Birfields this week-end and after inspection of the transfer case, it appears that a PO has been in there (excessive amounts of gasket sealant dried around the edges), but the test drive after the Birfields...
I apologize in advance for this really dumb question, however through the process of redoing my 92, I've found many things the PO changed that made no sense. I'm in the process of rebuilding the Birfields and the outer spindle assembly has manual locking hubs and no cone washers. I noticed...
My '92 3FE is sticky in the gas pedal and not in a good way. I've searched high and low for a replacement cable, but can't find an OEM or aftermarket replacement. Sheathing on the cable above the engine has deteriorated and PO spent lots of time on gravel roads such that the level of dust...
Just an update to this older thread....I'm redoing the interior door cards on my '92 fj80 which are garbage. Found the Australian Door Cards website based on the ebay photo above and ordered.... exchange rate made these about $108.00 US including shipping and I received them in 1 week to Iowa...