Recent content by aussielocker

  1. A

    Thrust washers needed, Aussie Locker Install RTH needed

    Hi Guys, Sorry, just saw your post. Sometimes we see carriers that are out of spc, so we've some up with a line of custom thickness thrust washers, available on our website. Torqmasters.com
  2. A

    Novice Questions about Aussie Locker install in '97 LC

    Thanks FLD2037! I try to browse the forums, but if you need help right away give us a call anytime or email :) CustomerService@aussielocker . com Office: 585-723 1489
  3. A

    Novice Questions about Aussie Locker install in '97 LC

    Hi Guys! 1.) Cross Shaft and pinion shaft are used interchangeably 2.) A thrust block slides over the cross shaft, non of the Aussie Locker designs reuse the thrust block - if you have one. 3.) Yes, full-float, easy to take apart 4.) Non c-clip 5.) Ring gear thickness doesn't really matter...
  4. A

    Aussie Locker clicking-when driving straight...

    Thanks!! We try to make an effort on the forums to provide tech support! I've been meaning to get on here for a while!
  5. A

    Aussie Locker clicking-when driving straight...

    Hi tlc762! We are new to the forum, but saw your post in a google notification. There are a number of things that could be going on, but most likely it's a soft or worn cross pin since your center gap is within spec. I would suggest replacing the cross pin and going through our troubleshooting...
Back
Top Bottom