Recent content by Attilio

Yes sir! They have been holding for quite some time now, I put much appreciated!!

FYI, the CCOT one is not the two piece acorn style like my tank connection. Perhaps sealant would suffice?

Sent you an email with specifics for order!

Copy...glad I asked. I will snug them down for now and tighten further if needed.

First time running and installing brake lines. I picked up a set of Rainmans lines, very nice quality, well labeled and match up very nicely to existing routes. Original fitting have been blasted and cleaned up by a solid FJ40 shop as new for a 1967 are not available. My question is how to...

Thanks for both replies above guys. My current tank is “clean” but has a small leak on the top seam that was repaired 15 years ago by a shop. I was thinking I was better off replacing the tank vs repairing it again. I am going to have too figure out if it’s easier to do the repair and...

Looking to replace an original 1967 gas tank. Looks like CCOT has 1968 and later available....anyone know where I can pick up a new tank for a 1967? As a side note, I am in the process of adding Fitech EFI with a Hyperfuel unit too the new tank.

Overall goal would be to bring it back to a daily driver as a loaner for my kids to drive when they turn 16 until they leave at 18. Overall, I have no desire to make it into a crawler or modify significantly. My thoughts are: 1. Change out drum breaks to disk. 2. Possibly keep the Ford 289...

A few pictures to show the current.

I am a lucky and blessed man that needs some help and direction....hoping you guys could lend a hand? At 15 I did no know it....but I got bit early.....as my first vehicle was a '67 FJ40....handed down from my Grandfather to my Father....and then to me. Other than my family, my FJ40 has been...