Recent content by AndrewCo

Nope, can't use a stock Toyota ECU with one, I put a Link on mine.

The CANTCU has been pretty good so far, it has an inbuilt "bench" flasher mode and with their new software when running their race+ flash you can enable things like transbrake, bump, virtual clutch, live tuning of shiftmaps etc. It requires a canbus capable ECU to feed it the data it wants for...

Tcase shifter bracket is still on the to do//finish list, I need to modify the mount I made out of some aluminium plate to get it on the right angle. The leather shift boot is an 05-09 Mustang one off Amazon for about $12 and fills the rectangular hole fairly well. Head unit/screen is an Eonon...

If its of any help this is version 1 of my RHD one in onshape. Depending on what the LHD tunnel looks like you might be able to mirror/flip the bottom piece and be pretty close. Version 2 was in Fusion 360 after a mate revised it for me but I'm fairly sure the measurements/tower heights on this...

On mine with the small bellhousing/short 8hp75 box the tcase ended up approx 13mm further forward compared to factory - no issues on slip joint spline engagement and factory tailshafts both fit. One thing I did notice is with the slight clocking that happens to the tcase if it was much further...

Mines a 2000 RHD UZJ100, stock diff gearing which I believe is 4.3 on stock tyres (31's?) The car came with some brand new half decent AT's so seemed like a waste to not use them - it will be getting some 33's when these wear out though. I just put a new aftermarket 80 series gear on the...

Sure: 1. Cantcu + Link G4X XtremeX - I made a plug and play harness by de-soldering the ECU connector off the Toyota board and added a MAP sensor, still kept the factory MAF but only for intake air temps. The factory DBW throttle works well also - even the cable one is still DBW, the cable just...

Got mine in last weekend, can confirm it's a big improvement over the unresponsive slushbox 4 speed. Cruising around with shift cuts and blips from the 2uz is also a laugh. I ended up going the same domiworks hf2av adapter kit and pressing an 80 series gear onto the input shaft + adding the...