Recent content by AMatts81

Yes, this is the type that was needed. I ended up finding them on Ali express. It was a #6 and #10 fitting. The #10 nut uses a m24x1.5 pitch and #6 is M16 x 1.5. Can’t for the life of me understand why no one sells these type of fittings in the US.

New Denso unit bought on eBay out of Indonesia.

Looking for some help here with trying to identify a couple AC connections. The backstory is that I purchased a Nippon Denso AC evaporator and control box for inside the cab, and all vintage air components are going to be used in the engine compartment. On the Denso AC unit, I need to...

Thanks for the info Carolina. I understand that for the truck it’s going in, there are a few pieces missing so I will need to adjust in order to make it work. The truck has the original 2f motor in it but the emissions equipment and carburetor was removed by a previous owner and was replaced...

I added more detail to the diagram to try and figure out if the harness you have is what is needed. Could you take a look at the numbers below and let me know if those are correct with the diagram above? The ones with the question marks I am not sure on and would need more input.

Hi. Thanks, for the quick reply. Just for reference purposes, I have been working off this diagram below. The AC system is going into a 75 FJ40 without factory ac. I am looking for these brackets for the controller switch: Also will need this set of brackets with the yellow arrows...

Trying to locate a set of mounting brackets for the under dash nippon/Denso ac unit and controller box. Also trying to locate the impossible L200 ac duct. Also looking to find the ac relay and harness that connects the controller box to the evaporator thermistor/blower motor/blower resistor...

That would be awesome. Keep me posted Thanks

Still looking for this cut out section if anyone has anything. Please send me a PM

Looking for a dashboard radio cutout for a 75. I had an earlier post looking for a radio bezel but this title fits more of what I’m looking for. Previous owners cut the dash to fit a larger radio so want to weld the original back in. Below is what I would need cut as the mounted tabs and...

Do you have a picture of it? Ultimately, im looking for the beveled sections and tabs locate inside on the left and right sides. In the picture below, i need the sections outlined in the red boxes. The green line is where the previous owner cut out the section on the truck now, so those tabs...

Hi, I know this is going to be a long shot, but does anyone have a tub that is heading to the scrap yard, but would be willing to cut out the section where the radio mounts if the metal is still usable? One of the previous owners of this truck cut out the metal on the left/right sides to...