So I finally ponied up to buy some long wanted half doors for my 78 FJ40 from Aqualu. There aren't any directions included, but the hinge installation was pretty easy. When I went to install the latches the way I though that they should go, the doors won't close and latch. There is not enough...
I have those parts from desmogging my 78 fj40 this past year. I was about to post this stuff for sale. Picture of what I have attached. Will be shipping from Alabama. PM sent
want to buy gas tank cover
I would like to buy the gas tank cover if it is not rusted and missing metal. I have a 78 fj40 and my cover has been eaten by rust along the front and outer edges. If yours is better, I'll buy it. Shipping to 35406. thanks. PM sent.
According to the link in the FAQ here : https://forum.ih8mud.com/40-55-series-tech/207394-mini-truck-powers-steering-hose.html
the fitting sizes for both the pressure hose and return line can be made yourself from parts from PSC Motorsports here: Installation Hose Kits : PSC Motorsports...
My idle speed is between 670 and 700 rpm. I disconnected the two vacuum lines to the distributor and plugged both with bolts. I should say that while going over the truck just to see what I have i've found that a po had done a half-baked desmog. There are several lines just hanging loose and...
I've been reading on MUD for weeks, have the FSM and a Haynes.
So my questions are:
#1Any ideas on why the timing mark is bouncing around?
#2 While changing out the plugs all came out easily but one plug will not easily thread by hand so I assume must be cross-threaded. I searched online and...
I have had this 1978 cruiser with 2F engine about a month. I tackled an emergency brake rebuild first since it wasn't working at all (thanks all for the help) . Changed the fluids. Next up has been a tune up. Bought the tune up kit from JT outfitters before I read all the bad posts about them...
Well, i did get the seal puller at autozone for $9.99 and it did the trick getting the seal out nicely. I also did buy a PVC coupler and used that and a rubber mallet to install the new one. I did order a new clip for the E-brake cable since i decided to go ahead and order a speedi sleeve...