Recent content by Ajk11235

Interested, sending pm.

Sold

Front coil springs shipped to 93465

Front coil springs (both)? Shipped to 93465

Added on Facebook and posted in the clubhouse. When do you guys meet? I came out to the campfire at surf and turf, it was fun. I will send a pm, thanks! I will check these out. I have heard of some on them. Thanks.

Count me in for sure. Name: Andrew Toy: 100 LC

Anyone have any interest in a Shaver Lake trip next weekend. I have never been, but I heard the Bald Mountain trail is open year round and I want to take the 100 out and do a little snow wheeling. Let me know if you want to meet up.

Hey guys, I am a farily resent transplant from the Pacific Northwest to the central coast of California (Paso Robles area). I am hoping to learn a little more about the area, and find some good trails/trips that are feasible to do in a single day. Is anyone from around here? Anyone...

Left everything in place. Masked off the paint about half an inch away the the molding. Once dry, I peeled the plasti-dip up to the edge of the molding where it tore along the paint/molding seam.

I have done emblems in the past, in fact it was my very first time using plasti-dip. It work pretty well. The best part is if you dont like it/fxxx it up you can pull it off and start over. If you need help finding a tutorial let me know. I know the 4runner guys do it a lot. Yeah, I couldn't...

Hey guys, Let me see if I can shed some light on a few of these questions. Please be advised, I am far from an expert when it comes to plant-dip, but I am happy to share my limited knowledge/experience. 8 cans all totaled up. Time will tell. I have used it in the past on other cars cars. It...

Hello all, Recently, I ('99 LC, Black, 170K) had a bit of a run in with a cement barricade in a parking lot (was an old lamp post barrier with the lamp post removed, so I couldn't see the barricade as I pulled out of the spot). Long story short, I sustained a bit of front end damage. I deiced...

Just as an FYI to all future searchers/anyone following this topic. This ended up as a full transmission rebuild. The clutch discs for the reverse year were completely shot. Total cost: $2100

I hadn't though of the E brake. This is very likely the culprit, as I cannot get the shaking, or possibly more accurately lurching, to happen with the break engaged. Is there a section in the service manual the may be of use? I am relatively new to these cars and, while mechanical inclined, I...

Forgot to mention it's a 99 with diff lock.