Recent content by Adarcy

Thx

What does the separator look like that sits right behind the tank for the 72?

Just picked this one up. FM6 Mounting it tomorrow with fresh aircraft cable tomorrow. Might switch to synthetic down the road.

I’ve always wondered about that. This 40 was already desmogged when I bought it years ago. All the emissions stuff had been removed.

The pins go with the base to the drivers seat. I’m keeping that base, the bucket seat mounts that I’m using reuse the base.

Just posted the stock setup for sale https://forum.ih8mud.com/threads/fj40-front-split-bench.1331184/

Selling my split bench out of an early 1972. I believe it fits earlier years as well. Only cons are in the drivers seat. The seat is a bit squishy and could use new foam. It also has a small tear in the side (see pics) and does not have the base. I reused the base for my buckets. Otherwise...

I'll take them. DM sent. Thx

I like the look of those Procars, but i'm thinking I need to ditch the bench seat frame and use some different mounts.

Ha! It certainly isn't. A bit like a being on a trampoline.

Hi all, I have a 72' (Dec 71 build) that currently has the split bench in it. At one point I pulled the bench seat setup and put in a set of Corbeau seats, but I never liked the look or that the passenger seat was much higher than the drivers side. Last weekend I pulled that setup and went back...

My picture won’t upload for some reason, buts it’s 20% off Genuine Toyota parts for vehicles 20 years or older.

I’m actually at Toyota Carlsbad now getting my 4Runner serviced. Didn’t see Russ, but this sign is on the counter. Probably applies to many of us!

I had a very similar problem. Ended up being the bushings at the top of the clutch pedal. $4 replacements and problem solved.

Thanks!