Big Thanks for your knowledge. Your schematics are great! I know this is an older post but I am fixing some of the issues from the PO. I have a 1973, 40 and I am trying not to destroy my ammeter by running too much through it. I like the idea of the 40amp breakers on the battery side and...
So this is what I have so far and thanks for the responses....7/16 fine thread grade 8...DOT requirement where the seatbelt attaches to the roll bar. M10 1.25 (1 inch and a 3 inch in length).
***Any idea what size bolt for the roll bar foot into the wheel well?***
I took a look at mine which is from a 1973 and the only difference I can see mine did not have a side dome light. The number of mounting holes appears to be the same as well. I attached a few photos so you can compare.
I need some help fellas. I replaced my wheel wells due to rot. Could somebody advise on the bolt size that attaches the roll bar to the wheel well support bracket? Previous posts said M10 x 1.25 but it seems a little small for the roll bar mounting hole. Any advice would be appreciated!