Recent content by 96GreatWhite

  1. 9

    Need a little help while on vacation/holiday

    Thanks. I wasn't sure, but was afraid of that. I will crawl under and have a look tomorrow.
  2. 9

    Need a little help while on vacation/holiday

    Hi all. My wife and I just drove from Dallas to Destin (approx 750miles/1200km) in our stock 96 land cruiser with the straight 6. Fortunately, I am a little paranoid and always check the fluids when we stop for fuel. I found the coolant low and was able to find some Toyota fluid at a nearby...
  3. 9

    tie rod end stuck to tie rod

    Just took quite a bit of elbow grease, but it eventually came off. Now on to the other side.....
  4. 9

    tie rod end stuck to tie rod

    I may end up doing that. I was able to break it loose with a 15mm wrench and a 1 meter cheater bar. But it is not moving easily yet.
  5. 9

    tie rod end stuck to tie rod

    96 80 series, just doing some routing maintenance. Left side tie rod end is stuck in the tie rod. End came out of the knuckle fairly easily and clamp came loose easily. But, threads are stuck in tube. Any tips? I have used loads of PB blaster and tried to move it back and forth. Completely...
  6. 9

    90915-YZZD3 Oil filter.... What size socket to get it off?

    I am having the same problem. I have a 14 flute, 73/74MM Blue Point that is slightly too large. I bought what was supposed to be a 73MM one online and was the same as my 73/74MM - slightly too large. When I put a caliper on them, they are both right at 74MM across the inside diameter of the...
  7. 9

    Rear Heater

    I was able to pull the sheathing out of the firewall grommet about a half an inch or so and reseat the spring clamp. Now the valve is traveling all the way to the stop. Test drive this evening. Thanks to all for your help.
  8. 9

    Rear Heater

    Yes, I am asking about how to adjust the cable running from the temp slider on the control panel to the water valve directly above the rear of the engine on the firewall. I pulled the little clip off that holds the cable, but the sheathing doesn't want to move easily. Don't want to break...
  9. 9

    Rear Heater

    I pulled the cable off of the valve lever and the lever is not closing all the way up. So I need to adjust the cable. There is a small clip underneath the cable that appears to be holding it in place. Do I just remove it and adjust the cable out or is there something else? Thanks!!!
  10. 9

    Rear Heater

    Thanks all! I will take the seat back out and do a little investigation. Hopefully just an adjustment needed.
  11. 9

    Rear Heater

    Thank you Kernal. I believe the system is as designed. All of the heater hoses were replaced recently as a part of normal maintenance that I do. The problem existed before that as well though. The cable is connected to the water valve and it is moving up and down as you change the...
  12. 9

    Rear Heater

    Hi all. 96 Land Cruiser question. After driving for a few minutes, heat begins to come from under the passenger (right side) seat. I took the seat out and tested the rear heater fan as well as the fan switch on the dash- both are working perfectly. Water is flowing into the little heater...
  13. 9

    '96 EGR Vacuum Line kit

    Thank you Malleus! I will get everything on order! This is actually the first time the CEL light has come on since I have owned the car.
  14. 9

    '96 EGR Vacuum Line kit

    I have the 401 code and will be cleaning passages, changing vacuum lines, etc. soon. I saw that a firm called 'wits-end' used to have a vacuum line kit for the EGR related hoses, but that they are no longer in business. Is there a similar kit available or do I need to order the hoses one at a...
  15. 9

    Climate Control Panel Backlights

    Lights on order. Next will be steering wheel and shifter handle recover......
Back
Top Bottom