Recent content by 91lcruiser

  1. 9

    1991 fj80 need new head bolts!?

    I've been trying to find new head bolts for my 4.0 3fe engine but not having any luck. Any of you guys had any luck with this?
  2. 9

    3FE runs rough, just rebuilt.

    I get over 125psi compression in #2, and im getting fuel, it was wet in there when I had the exhaust manifold off. The valves should be sealing good enough if im getting that much compression right? I looked in at the valves and rolled the engine over and when the valves were closed I could see...
  3. 9

    3FE runs rough, just rebuilt.

    Still running rough and missing on #2. I removed the intake and and the exhaust manifold for #1-3 cylinders. In #2 it was wet on both the exhaust and intake ports which would make you think that it is not firing or losing spark somewhere. So I put it all back together and ran it in the dark, and...
  4. 9

    3FE runs rough, just rebuilt.

    Compression is about the same throughout, #2 is at 125. I swapped plugs and tightened them down and still no change. Rechecked my valives and they are good. Intake hose is good, no cracks at all. I have not swapped injectors again yet. I just read the codes on it and there is code 41 for the...
  5. 9

    3FE runs rough, just rebuilt.

    The plugs are fine, they are brand new and I've also had the plug out of the cylinder with it running and I can see the spark. The injectors got swapped around when I took them out to check them out, and they are brand new so the shouldn't need cleaning, and when they were out I put a little...
  6. 9

    3FE runs rough, just rebuilt.

    Sorry, I did not explain it very well in my first post. I can unplug #2 spark plug wire while the engine is running and there is no change, but I do have spark. I can also unplug #2 injector wiring and there is no change in the engine. But I know that the injector wiring is fine because I can...
  7. 9

    3FE runs rough, just rebuilt.

    So I made a mistake, I was running the engine while doing the compression tests on each cylinder, and my amazing compression gauge from harbor freight was not keeping up. I unplugged the main distributor wire and then tested compression and it is within specs. I also took off the intake and...
  8. 9

    3FE runs rough, just rebuilt.

    Ok, i will try doing that in the morning then. Im just really hoping that I dont have any issues with my rings.
  9. 9

    3FE runs rough, just rebuilt.

    Its only been running for a few days, and I haven't driven it more that a few blocks. Its been running like this ever since I rebuilt it and first started it. I checked both the block and the head to make sure that they weren't warped. I just checked the compression tonight so that is the way...
  10. 9

    3FE runs rough, just rebuilt.

    I have a 1991 cruiser with the 3FE engine. It has just over 60k miles on it. The previous owner had over heated it badly. I took it all apart and found blown head gasket and a few of the pistons were starting to melt from over heat. I put all new pistons and rings in and all new gaskets of...
Back
Top Bottom