Great, thanks so much! I’m going to mess around with it as is this week and update from there I think. I have a 3hr drive on Tuesday and again Wednesday, so I will test the set up pretty well then ahah.
from what I was reading is people thought that 20 would be too much for a 3b? How long have you been running that? I meannnn more doesn’t sound bad to me, haha but right now I was blown away with the little 10psi difference for the truck :rofl:
Wow, really cool about the HAC!
It’s running and starting just like usual now!
Very happy about the turbo however, just pushing 8-9 psi, no need to push the motor too hard… just good to get over that lack of get up and go power that the 3Bs have. took it for a test drive today and EGT’S only...
Update: started just fine this morning in -10°c really not sure what happend as I’ve heard it’s not as if you can flood a diesel? The trucks never not started before.
So, sadly I wasn’t paying attention… on first start up after turbo install on my 3b I had a rag in front of the turbo and it sucked it in. (It was running perfectly for 5 mins before it happened.) I ran to turn it off, I’m not sure if the rag or the key shut the motor off first but ether way…...
Hey guys, It seems crazy to me but my water pump pulley grenaded its self! Can’t seem to find one anywhere!
Anybody have?
I’m located in Ontario Canada 2hrs from Toronto but also have someone flying here from Seattle Washington in the next two days that could pick one up in that area! If none...
Hey guys, It seems crazy to me but my water pump pulley grenaded its self! Can’t seem to find one anywhere!
Anybody have?
I’m located in Ontario Canada 2hrs from Toronto but also have someone flying here from Seattle Washington in the next two days that could pick one up in that area! If none...
Yeah no worries, if you can’t make the sliders on those seats work I do suggest buying a pair of Sparco ones it’s a pretty nice mechanism and I think they’re relatively cheap off the website
Thanks, I think so as well.
The PO made it so I’d have to remove the gas tank to to remove the sparco rails. Working on gravel I opted to leave them installed haha… plus he did a nice job with Billet aluminum risers, and the rails are good quality and provide a flat 4 bolt pattern on both...
Thought id update since I said I would. Changed my mind last min and cancled the order on the procars. I didn't see the point buying brand new seats only to spend more money to re-upolster them. I bought these seats off a buddy for $250 and sold the previous ones for $600. They are from a '99...