FWIW, when removing various parts to access the light assemblies be prepared to have many broken plastic clips and rivets. I have replaced lights on vehicles of similar age and those pieces are basically consumables.
Just a head up on the ppf. I had laminx on my wrx lights and it ruined them when it was time to replace. I used heat and a steamer on them and it still pulled the factory clear coat off the lens. Im not saying they all will do that but I wouldn't...
One more thought..
On my original lamps for a while I did try applying a nice synthetic car wax, hoping the UV protection in it would prevent yellowing.. doesn't seem to have made a difference at all.
It'll be PPF for me in the future. Just...
I found someone selling a pre-cut ppf kit they never used. If I were too do it again would definitely take to a ppf place to make the cut and fit perfect
What I would do- is buy a new set of later model (2013) HID headlamps and install- there's some wiring changes that would need to be done, but not too hard.
https://forum.ih8mud.com/threads/headlight-upgrade-2008-to-2013-with-hid-drl.912826/
I was very happy when I replaced my 2013 headlight buckets with new factory parts, even after they had been polished previously.
Whether you’ll notice more light will depend on how bad your current ones are, but if they are yellowed there will...
Swapped out mine a few years back. The color is clearer but depending on how bad they are yes it'll be brighter since there's nothing disrupting the light.
Will require removing the bumper, or at minimum undoing the sides and pulling it off just...
I have a 2008 with 145k miles. The headlight assemblies are pretty ratty by now. I am contemplating ordering two new assemblies from Toyota. My question - will the new headlights be quite a bit brighter then the cloudy assemblies? Are they...