Recent content by 3TracksNTheSnow

  1. 3

    Low Idle and Lifters Ticking After Starter Replacement

    Good news! Replaced the temp sensor, and it started strong! Idled smoothly at 900 cold and warm at 700. I bought a stethoscope and the ticking seems to be coming from the injectors. Cleared the codes and took it for a drive, drove great and no codes were given afterwards. Thank you guys for your...
  2. 3

    Low Idle and Lifters Ticking After Starter Replacement

    Okay will do, it's instock at my AutoZone and I'll reply tomorrow with the result.
  3. 3

    Low Idle and Lifters Ticking After Starter Replacement

    Okay, so injectors possibly? I only know what I've read about. I'm young and completely self taught from reading. Going to try the 'screwdriver stethoscope' test tomorrow on the injectors and on the valve cover to try and nail the tick.
  4. 3

    Low Idle and Lifters Ticking After Starter Replacement

    And that could create an issue straight off a start? Not something like a malfunctioning temperature gauge?
  5. 3

    Low Idle and Lifters Ticking After Starter Replacement

    The knock sensors were undamaged as far as I know. The sensor I was referring to is right next to the starter itself. However, the temp sensor you identified is damaged. I don't think I did it, it looks old but...anything is possible. Could that cause the idle issue?
  6. 3

    Low Idle and Lifters Ticking After Starter Replacement

    The black sensor closest to the starter had a broken clip when I got to it. I pressed it together an put a spot of JB Waterweld putty to keep it together just in case.
  7. 3

    Low Idle and Lifters Ticking After Starter Replacement

    Would letting it idle so low be advised to see if the ECU could normalize the air/fuel ratio? Shouldn't it have defaulted to a stock ratio where it runs and wouldn't die when given throttle? I'd go take it for a drive but I'm worried it won't end up back in the driveway if it dies on me.
  8. 3

    Low Idle and Lifters Ticking After Starter Replacement

    Hey all, I recently bought a 99 Cruiser with 290k on the clock. The starter went out last week. (no click, no start) I followed exiting threads to learn how to pull the manifold and replace the starter. After buttoning everything up the truck wouldn't start. I had a friend helping me when I...
Back
Top Bottom