Recent content by 377

I appreciate the answer to my question. As far as the steering goes the drag link and tie rod are going away when I do the saginaw conversion. I guess my actual question was whether the spindles would bolt on to the knuckles I mentioned. Because I feel like if the spindle bolts on the...

Hello, I apologize in advance for asking what might be a really stupid question but, I have been searching for several days and not found an answer. I have a 1972 FJ40 that I installed a JT Outfitters front disc brake conversion kit on. The JT kit went together pretty well and the disc brakes...

Can anyone tell me if any manufacturer makes a replacement gasket for the oil pressure regulator? Also the seal that goes on the piston assembly inside the regulator is this something can just be replaced with an o ring of the correct size or do I need to buy a specific o ring? I know Redline...

Thank you for help Byron Thank you for your help Byron. I appreciate the information on the different turn ratios too that was a handy piece of information. Thank you again

I have emailed 4x4 Labs twice and never received an answer to this question. As far as the installation goes the kit is welded in. The kit has plates that are welded to the inside and outside of the frame. These plates are made to be welded in specific locations and are drilled so the steering...

Hello, I recently purchased a 4x4 Labs Saginaw Power Steering Conversion Kit. The kit is really well made and was easily installed on my rig. My question is what would be the best readily available steering box to use with this kit? Any help you guys might give me would be greatly appreciated.

That’s a really clean looking rig! I’m slowly but surely getting mine in order. I haven’t looked at the back mounting holes to see if the holes line up. If they don’t I’ll put nutserts in. I have a nutsert tool somewhere around here. I’ll probably put nutserts in the rocker too. I replaced the...

Thank you for the answer it’s greatly appreciated. The tank is a replacement tank and the strap ends are probably about an inch off the floor and held in place with what appears to be some kinda of lag bolts for wood. I’m sure those are factory! Thank you again for the help. Paul

Hello, I have a 1972 FJ40 that did not come with a fuel tank cover from the factory the best I can tell. I would like to install a cover on mine so I found one. I understand on the door side there are a couple bolts that need to be added. My question is about the two bolts on the back and the...

Riverrocket, You won’t be disappointed. These things are great and beyond beefy. Jr. is a great fabricator and a top notch person to do business with.

Jr. Are you still making and selling your rocker panels? I need a set for a 1972 I’m building. I tried sending you a PM but I’m not sure if I did it right. I’m new to the site so I’m trying to figure out how everything works. Thank you and I look forward to hearing back from you. Paul