Recent content by 2dogs

  1. 2

    CLUTCH FORK WOES

    Great information! I am going to finish the trans connection today, gotta take a "stab" at it and if that doesn't work I like the idea of depressing the fork to help the pilot bearing alignment. Wish my frame looked that pretty 73FJ! My old tub is just a trail rig at this point and trying to...
  2. 2

    CLUTCH FORK WOES

    Thanks for the replies, I unbolted the slave and installed the TO bearing in fork. Jacked up trans and got it started into bell housing. Ran out of steam for the night. I should be able to wiggle in to the pilot bearing tonight. Appreciate the input.
  3. 2

    CLUTCH FORK WOES

    Thanks for the reply. If I understand you correctly after trans is in place then I connect the fork to hub and reconnect the slave. Do I have it right? I was thinking the hub and fork should be connected before I slid the trans back in.
  4. 2

    CLUTCH FORK WOES

    Hi guys, Putting in new clutch in my 69 Fj40, all stock, 1F with three speed tranny. All going well till I installed the release lever. It appears that the fork is sitting below center of the clutch housing and when installed the TO bearing will not ride the clutch levers properly. I am banging...
  5. 2

    69 FJ40

    So you probably remember South Street, if you drove to the south end of it there is an old farm that I grew up on. Dad was postmaster in town for many years. Small world!
  6. 2

    69 FJ40

  7. 2

    69 FJ40

    Thanks for the info. Grew up in Morrisville NY and used to bang around in the Adirondacks before I moved to AK.
  8. 2

    69 FJ40

    New member to site. I've been following for a few weeks and great site for info. I am rebuilding 3/69-9/69 Aisan carb and looking for float clearances. Waiting for FSM to arrive and hoping someone can PDF the carb spec page with this info. Thanks
Back
Top Bottom