The terminals release from the fuse box fairly easily, you need to have a pick to release the lock tabs. They make tools specifically for this, I’ve always has good luck with a small flat blade precision screwdriver. There’s some good info on...
The 3FE actuator and actuator to throttle lever cable fit. On 1HD-FT anyway. 1HD-T should be the same.
Original 1FZ pedal to actuator cable will fit as well. It's a bit longer than the proper 1HD cable, but you can route it slightly differently...
Guilty. I have been hesitant to sell in case something happened to my IC and i needed to be able to run it w/o or if I sold motor, but I also don’t like someone out there hung up for lack of pipe. Shoot me a DM, maybe you can talk me out of it.
Ahh..the boost gauge is more of fit with the aesthetics of the factory gauges I think. I definitely like the gauge location and would do same again despite the time and effort it took. Haven’t researched other gauge options or brands. Perhaps...
Performed fairly well, but the pyro has had to be replaced under warranty once already, and the current one often just intermittently reads incorrectly and then snaps back into line. If I was doing it again I’d use something else.
the 0-15...