gifu

Sure.

Heavy duty rear bumper for FJ60. Holds up to 35" (probably larger) spare, jerry can, hi lift. Was on my FJ60 when purchased. Needs a coat of paint, but otherwise in good shape. Asking $750 Located in Truckee, CA. Can get it to Stockton or...

Very stout, custom dual swing out fits FJ40. includes corner protection. Tire carrier uses entire wheel hub, spindle, bearings, rotor for front disk brake (as spares). Does not include birfield inside hub. Other side is a cage to carry wet or...

Wow, great work. LHD swaps aren't that hard... but this is a complete body swap, harness swap, etc... lots of work. I've got that LHD 12-volt harness ready for yah...

Absolutely insane conversion. Props to you for getting it done. I'm 2/3 through a 2LT to 1KZT conversion in an LJ77... and seeing what you have to deal with in a cab-forward truck has silenced my complaints about my own project. Good on yah.

I have had this cruiser for close to 20 years, time to move on to other projects.  Low gears, lockers, left hand drive, 12-volt. I combined three Cruisers to build this: a RHD BJ74, a LHD BJ70, and a HZJ75. The engine is a low mileage (35k)...

You absolutely do not need a secondary lift pump... but man I like running one. It makes swapping filters and bleeding lines a snap. I often install a Walbro FRB-5 because it is a pull through pump, so if it ever quits (have not had one die...

Nice rig. 5000 original miles is crazy. Super clean. The updated front clip is growing on me.

I've been for a ride in this... it's got so much soul. It's beautiful.

yup those look dead on. you got a video of the engine running/shaking? Did you do any other work at the same time?

Did I miss it, or was there no mention of an intercooler? It's a must... G-Turbo on stock fueling will actually increase power... it shouldn't...but it does. They are pretty incredible turbos. I like your idea of measuring the throw of the...

so rad.... uhm... where can I find this? I need the same but for 1HDFT...

Bellhousing. 3Bb to H55f or H42 Probably came from BJ60 or BJ75 Bellhousing only. $250 obo Truckee, CA

can you detail pics of the long range fuel tank? is it in the back or under the seats? can you take some pics of the power steering box and steering shaft (column to box). looks like it has an overdrive? is that a advance adapters box?

This is a GT25 Turboglide kit to upgrade your turbo on a 2LT or 2LTE. It has a custom manifold. It will fit in a LJ77… but the exhaust is very tight against the firewall. I’ll include the first bend. It will also fit in a Hilux. Comes with...

message me direct. Othwerwise this motor is sold.