Recent content by 1995cruiser

That thing is way to nice to take out in the rocks like that. Wrong rig maybe for what you are attempting. It is really to nice man.

Wow I was having a good time reading this poor guys post WOW that just came out of nowhere. He was getting his mad on.

jcardona1 and all thank you for helping me. You nailed that one. I have attached pictures. The Fix . After reading all suggestions from the group, I started out by welding a 1/2" thick Plate on top of the existing bump stop pad. This helped me loose a 1/2" of my problem. When the suspension is...

Im working on that right now but I found lots of front end out of wack. Thanks ill post where I'm at after some words with her.

Landtank is that really the fix?

So I noticed the bump stops lands only on the edge of the welded box bases not centered. I welded a piece of 1/2" plate 1 inch longer over the entire pad to make the bump land within the base all the way. The half inch plate I added leaves me with only about a 1/2'" to deal with clearance fully...

This is about 1.5" from bottom out. and almost touching.

almost hanging from the straps.

Sorry for the large pictures I assume they will be. I tried to shrink them but failed.

Hello I have been working on this modified 1995 landcruiser and have literally hit another road block on my steering. During or before full front suspension compression, Pitman arm tie rod are contacting hitting the crossover linkage. I have found some posts on another forum with similar same...

Landlocked93 and Jonheld thanks for the feedback regarding. I definitely know a little more about this truck from this session. I would love to have full vol 1-2 in an electronic copy. So its to late to say but my truck is running really good. I found the crank sensor plug was shotty on the...

Yea that's what I'm getting at. I have covered a lot of stuff trying to hunt this down. When I purchased this thing I new it had some issues that he owner wasn't telling me about. The day they brought it to me on a trailer they all looked at each other like here it goes and when it started they...

I can dig some up. Do you know if this 95 specific year has a fuel cut off safety tip over switch or anything related to fuel.

I disassembled the truck electrical all the way from ECU to engine compartment inspected all harnessing and used electro duct to make new harnesses. The vehicle has lots of sharp Sheetmetal all the way along the harnessing. Added 6 grounds from block to frame and body. eliminated all of the rear...