1996 FZJ80 Sold!
Selling my 96 FZJ80. Located in West Phoenix. Bob 623-764-5197
rmkessler3@gmail.com
Asking 15,000
Factory lockers
315/75RX16 KM2’s 85% tread with Discount Tire Certificates
172,000 miles on odometer but does not reflect actual mileage due to 7% percent gear reduction at approx.. 70,000 miles. Speedometer shows 72mph at 65mph
Mobil 1 synthetic in power steering and transmission
Dual Battery System with rear outlets and interior fuse blocks Coherse Switch for Winch.
Optima Yellow and Sears Diehard
Wiper fluid relocation kit installed
Slee Transfer Case Skid Plate
Slee A/C Dryer Skid Plate
Slee Driving light harness
Toyota auxiliary light switch. HID Lights
African Outback drawer system with fridge slide
Warn M12000 winch
Safari snorkel
Re-geared to 4:88
Slee off-road 4” Lift medium front with 30mm spacer, progressive heavies in back
Custom front driveshaft double cardan with spicer u-joints
Ome shocks n73l front n74l rear
New Ome steering dampner
Slee front control arms with bushings
Castor correction plates
Slee adjustable front and rear panhard
Slee adjustable rear upper control arms
Breather extensions
No front swaybar
Part-time kit installed by Slee off-road with avm hubs and center diff lock switch
4+ control arms and relay rod 80 Series Rear Lower Control Arms
ARB Bull Bar with CB quick disconnect mount
Hanna Quality Sliders
Hanna Quality rear tire carrier
Fenders removed holes welded and spray liner applied
Factory roof rack removed and spray liner applied
New leather a couple years ago for front and middle by AATLAS1X driver seat has new Toyota seat foam
Blue fan clutch mod
Installed inverter
Newer OEM radiator Toyota Red only with distilled water
Power antenna needs mast
Some buff marks on body from detailing, some AZ pin-striping, fade on center of hood starting (not bad)
Right rear quarter panel had trail damage. Now repaired and painted.
P0401 code New VSV Valve and EGR modulator to be installed tomorrow
Just replaced crankshaft seal, and distributor seal
No FOB
PHH Kit installed (Blue Hose)
OEM Birfields ABS rings removed but included
Includes some extra parts. New AVM hubs, Fan Belts, U-joints, C-clip, 2 used birfields
Downloading more pics as I get them.
Selling my 96 FZJ80. Located in West Phoenix. Bob 623-764-5197
rmkessler3@gmail.com
Asking 15,000
Factory lockers
315/75RX16 KM2’s 85% tread with Discount Tire Certificates
172,000 miles on odometer but does not reflect actual mileage due to 7% percent gear reduction at approx.. 70,000 miles. Speedometer shows 72mph at 65mph
Mobil 1 synthetic in power steering and transmission
Dual Battery System with rear outlets and interior fuse blocks Coherse Switch for Winch.
Optima Yellow and Sears Diehard
Wiper fluid relocation kit installed
Slee Transfer Case Skid Plate
Slee A/C Dryer Skid Plate
Slee Driving light harness
Toyota auxiliary light switch. HID Lights
African Outback drawer system with fridge slide
Warn M12000 winch
Safari snorkel
Re-geared to 4:88
Slee off-road 4” Lift medium front with 30mm spacer, progressive heavies in back
Custom front driveshaft double cardan with spicer u-joints
Ome shocks n73l front n74l rear
New Ome steering dampner
Slee front control arms with bushings
Castor correction plates
Slee adjustable front and rear panhard
Slee adjustable rear upper control arms
Breather extensions
No front swaybar
Part-time kit installed by Slee off-road with avm hubs and center diff lock switch
4+ control arms and relay rod 80 Series Rear Lower Control Arms
ARB Bull Bar with CB quick disconnect mount
Hanna Quality Sliders
Hanna Quality rear tire carrier
Fenders removed holes welded and spray liner applied
Factory roof rack removed and spray liner applied
New leather a couple years ago for front and middle by AATLAS1X driver seat has new Toyota seat foam
Blue fan clutch mod
Installed inverter
Newer OEM radiator Toyota Red only with distilled water
Power antenna needs mast
Some buff marks on body from detailing, some AZ pin-striping, fade on center of hood starting (not bad)
Right rear quarter panel had trail damage. Now repaired and painted.
P0401 code New VSV Valve and EGR modulator to be installed tomorrow
Just replaced crankshaft seal, and distributor seal
No FOB
PHH Kit installed (Blue Hose)
OEM Birfields ABS rings removed but included
Includes some extra parts. New AVM hubs, Fan Belts, U-joints, C-clip, 2 used birfields
Downloading more pics as I get them.
Last edited:
