83 fj60 for sale, seattle, WA

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Location
United States
83 fj60, seattle, WA (ARB, WARN, IPF, Flowmaster, BFG MTR, NV4500, 6.2L Diesel!

I am moving out of the country and am selling everything I own. This includes my 1983 FJ60 Landcruiser project with 6.2Liter diesel and nv4500.



It is currently misfiring, 2F engine needs rebuilding or replacing. For an additional cost I will replace the motor with a good running 2F inline 6(stock motor)



Interior is very clean, and everything inside works. I even have the original toyota tool kit that came stock with the truck.



the truck has appx. 150,000 original miles on the odometer, not sure how many miles on engine. It has passed the date for emissions requirements and has been fully desmogged.



I have installed the following aftermarket parts:


Flowmaster dual outlet exhaust, sounds like a small block!


ARB Front Bumper, slightly bent


Warn 8000# winch, works great and includes controller.


IPF Driving lights, bright as hell


Bosch fog lights


New 33" x 10.50" R15 BF Goodrich Mud terrain tires with full tread on steel wheels.


Yakima roof rack with safari basket, not currently installed.



Currently the truck has 2 bulletholes in the glass, one in the windshield, and one in the side cargo area. I have the replacement glass included, just don't have the time to replace it.



The truck has been used as an off roader, and has some dents. The photo's do not show the dented rear drivers door. There is a door available to replace said door if you care, as is it opens and closes and doesn't leak water.



I am including a GM 6.2 L diesel engine(less than 6000 miles, all accessories included and brand new GM hydroboost brake booster and new starter,) an NV4500 5 speed manual transmisison with bellhousing, clutch, master and slave cylinders that I was going to swap in. This would make an awesome project and I have already located the most difficult to find parts for you! I'll give you my research on how I was going to do the swap...



I will sell the entire project for $5000 o.b.o., which is a $3000 loss for me, but I am willing to remove some of the aftermarket parts and sell them separately as well as the diesel, nv4500 clutch, bellhousing, etc in a month or so if no one buys the whole project.



please call me at (206) 353-9352, as I am never near a computer anymore. Please don't waste my time, I have a very short time to sell all of my posessions and am busy. I was going to finish the project but now I am leaving the country to visit my twin brother in Moscow Russia for a year.

I will give any one on mud a better deal cause you guys have helped out so much. Please spread the word, as I only have till the end of july to move and sell everything I own. you guys rock!
 
Last edited:
Back
Top Bottom