Your thoughts on AC/Heaters

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

2nd that. All the hotroders use them. The only complaint is that if you run it on coolest w/o fan on high, they tend to freeze up. So if you want it cool, but not cold, just turn the temp up, not just the fan down. Probably due to the fact they have smaller evaporator coils to fit more applications. Nevertheless, a quality, time-tested unit.



Ed
 
Also I have one of the models that uses vacum actuate controls - they now have servo motors - when I am at low idle - the heater door has a hard time opening fully. Not a big deal.

The install is clean and compact - and the company has excellent CS- worth the $$
 
On a custom bracket that comes with the unit above the alternator. Go to their website and download the .pdf instruction. I have one and love it.
 
The vintage is self contained, in that it uses nothing from the factory heating system, it's all removed. It contains heat, air, and defrost in a single unit. Your factory heater bits are up for ebay after installation. It does have the compressor and bracket, of course, along with the condenser and drier. I will say the piece that mounts to where the old fan blower box is is s***. It's a crappy plastic piece that cracks very easily. If you go vintage, throw that crap in the trash after having it duplicated at a sheet metal shop. While the air is cold, you need to insulate a 40 with window tint, and under floor (mat) insulation if you want to be comfortable over about 85 degrees.
 
Back
Top Bottom