won't start after nav install??

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 28, 2007
Threads
21
Messages
94
I installed Pioneer avic d3 per instructions here on '95. It tested fine and car started. I reconnected all dash connections with negative battery still connected - first mistake? Vehicle would not start after everything was back in place. I have power and clicking noise near fuse box under hood. All those fuses and underdash fuses look okay. I disconnected new unit just to be sure but still won't start. Any ideas?
 
You shouldn't have had to do anything with the wires going to the starter right? Maybe just coincidence? I know 80's have some starter issues, can you check and see if you are getting 12v to the starter solenoid?
 
Thanks all for advice. Just to verify - The ground looks good, I have constant power to the large wire at solenoid and I have power to the wire with clip when the key is turned to start.
I'm hoping this rules out other possibilities. I did the starter contacts mod a year ago, I'm leaning towards a rebuit starter right now. :confused:
 
Whack the the starter with a hammer before another more tech answer comes along :D seriously.

Someone mentioned alarm. In the past my vehicle has been towed because the (professionally installed) aging aftermarket alarm was messing up the start circuit somehow, and died on the roadside 1000 miles from home. Toyota spent 3 hrs on it without a solid answer. It would miraculously start, but the alarm system became suspect. Once I refurbished the alarm components, those gremlins disappeared entirely.


TY
 
Whack the the starter with a hammer before another more tech answer comes along :D seriously.

Someone mentioned alarm. In the past my vehicle has been towed because the (professionally installed) aging aftermarket alarm was messing up the start circuit somehow, and died on the roadside 1000 miles from home. Toyota spent 3 hrs on it without a solid answer. It would miraculously start, but the alarm system became suspect. Once I refurbished the alarm components, those gremlins disappeared entirely.


TY
Tried the whack, but got nothing. Alarm gremlin is cause for concern. If I have power to both starter wires on ignition shouldn't I get some action from the starter if it were not faulty? Wouldn't alarm cutting in prevent power to one or both starter wires?
 
Tried the whack, but got nothing. Alarm gremlin is cause for concern. If I have power to both starter wires on ignition shouldn't I get some action from the starter if it were not faulty? Wouldn't alarm cutting in prevent power to one or both starter wires?

You mentioned "starter contact mod". To me, "mod" means modification. What starter mod have you done or have you simply replaced the contacts and the plunger?

If you have power to both starter wires, then it should start if there are enough amps passing through to turn the starter.

Triple check the battery connections. The ground is very important for starting. I agree that the alarm probably is not the issue since you have +12v at the starter but it won't spin.

-B-
 
Back
Top Bottom