wiring bend-tab sleeve (1 Viewer)

[SteadiCruiser]

Tidying up my new wiring harness on a freshly painted body and wondering how to dress those bend tabs.

Originally they had little plastic/rubber-like sleeve covers to protect the wire and, presumably, protect from paint cracking and rust creation.

Before I come up with too much of a "creative" solution are there any good restoration solutions?

Tried googling but couldn't come up with anything.

 

[Dizzy]

weld a tab, then electrical shrink wrap it

i've seen Plasti Dip for the handles of pliers, etc. never done it

'restoration' is merely an approximate and theoretical concept, or I've watched too much antique road show

no serious, I'd like the shrinkwrap to match the factory colors, and fix the tab missing on my brakeline on the rear axle.