Windshield wiper stalk question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 24, 2019
Threads
20
Messages
87
Location
OHIO
Can someone tell me if the windshield wiper stalk on a '97 FJ80 should pull forward to spray fluid on the front windshield? I seems like no matter what I do, I get spray on the front and rear window. I've already replaced the diverter, but perhaps the stalk is suppose to pull forward, as mine does not.

Thanks,
Andy
 
Can someone tell me if the windshield wiper stalk on a '97 FJ80 should pull forward to spray fluid on the front windshield? I seems like no matter what I do, I get spray on the front and rear window. I've already replaced the diverter, but perhaps the stalk is suppose to pull forward, as mine does not.

Thanks,
Andy
Not quite sure of your question. Are you trying to aim the spray? You just stick a pin/needle into the nozzle to adjust where the spray goes.
 
Not quite sure of your question. Are you trying to aim the spray? You just stick a pin/needle into the nozzle to adjust where the spray goes.

I'm asking if the wiper stalk, inside the truck, to the right of the steering column should pull forward to spray fluid onto the windshield. Mine doesn't seem to pull forward, all I can do is press the button on the end of the stalk, which sprays fluid on the front and rear windows.

-Andy
 
I'm asking if the wiper stalk, inside the truck, to the right of the steering column should pull forward to spray fluid onto the windshield. Mine doesn't seem to pull forward, all I can do is press the button on the end of the stalk, which sprays fluid on the front and rear windows.

-Andy
Ah. To my knowledge, no. Not forward, not up, not back.

Mine is a '97 as well.
 
Ah. To my knowledge, no. Not forward, not up, not back.

Mine is a '97 as well.

Ok. So when you press the button on the end of your stalk, does it only spray fluid on the front windshield or both? It seems like no matter what I do, the fluid sprays on both windshields. I had read before that it could be the diverter, which I already replaced, but doesn't seem to have changed the behavior.
 
Ok. So when you press the button on the end of your stalk, does it only spray fluid on the front windshield or both? It seems like no matter what I do, the fluid sprays on both windshields. I had read before that it could be the diverter, which I already replaced, but doesn't seem to have changed the behavior.
It's *supposed to* only spray the front.
 
Pushing end should spray front. Twisting end should spray rear
 
Mine sprays both too, but I just turn on the rear wiper and clean all of em at the same time.

It is kinda annoying now that you mention it

Tell me about, very annoying....wondering what the issue is since i've replaced the diverter.

Pushing end should spray front. Twisting end should spray rear

Any idea what the issue might be since it is spraying on both and the diverter has been replaced? Some sort of wiring issue? When I twist it, it only sprays the rear, it's when I press the button on the end, that it hits both windows.

-Andy
 
Possible a PO already attempted the repair and hooked it up incorrectly? Then you plumbed the new part the same way? Just tossing out an idea.

I have a stalk question ... anyone know why my rear wiper only works once on the intermittent setting, but never moves again after the first cycle?
 
Possible a PO already attempted the repair and hooked it up incorrectly? Then you plumbed the new part the same way? Just tossing out an idea.

I have a stalk question ... anyone know why my rear wiper only works once on the intermittent setting, but never moves again after the first cycle?

I never thought to check to see if it was hooked up incorrectly, and that was it. Checked it this weekend and attached the hoses correctly, and now it behaves as it should. This forum is a valuable tool - thank you again!

-Andy
 
Back
Top Bottom