Window up problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

brownbear

Mod in Hibernation
Moderator
Joined
Sep 6, 2004
Threads
121
Messages
7,187
Location
Hamilton, Ontario
Hi guys, just got my wife a 91 FJ80 over the weekend for her to drive. Something safe and fits all three kids :)

Got a question about the drivers front side power window. When I select it up when it hits the top the window does not stop traveling, instead it bounces up and down a little. Quite violently..

Is there a limit switch to clean or replace there? Other than the over travel thing the window works fine.

Oh I must say too... I did try to search. I never got a hit on this... But I did not know the terminology either.. :)

Thanks, BB
 
You and Waltz need to get together and brainstorm (https://forum.ih8mud.com/showthread.php?t=169080)

I was wondering if Waltz's problem couldn't be the "limiter" but the opposite problem of what your seeing. I'm not sure of the correct terminology but it seems your "limiter" isn't working and it seems maybe his is working too well (i.e. window won't go back down).
 
I just thought of this. I bet your drive gears are loose. Loose enough so that it can jump gears when it hits the top. If it were tight, I think it would realize it was home and stop. Open it up and see if everything is bolted down tight.
 
Just wondering if anyone else has any ideas before I tear into it....? Also a bump for the night readers... :) Man this 80 section moves fast.
 
my drive gear was loose and it caused all kinds of problems including clunkety clunk gear slips going up. once you get the window motor out, separate it from the regulator and pry the round thin metal cover off the motor and you should see a snap ring, a round metal weight to seat the gears and plastic gear set tat engages the motor plus the metal gears and shaft itself that engages the regulator. the snap ring on mine had come off and the gear had found an uneasy off centre equilibrium. I had to canibalize parts off an old rear window motor I had as these parts were trash. Don't do this unless you can take the vehicle off the road as if it all falls apart when you open it then there is no way to keep the window open!
 
Thanks Semlin. I will try to plan something before going into there.

The window works. I just have to time it perfect on the switch or it bounces back down from over traveling. Hopefully other toyota's use this motor design, so I may find parts at the wreaking yard.
 
Back
Top Bottom