Will this work?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 13, 2003
Threads
71
Messages
786
Location
Folsom, CA
First picture is the original 1973 master cylinder I have been running on FJ40 for the past 5 years. Removed the residual valves because it has 4 wheel disc brakes but it has slowly developed a leak from the sensors on the bottom side.
The second picture is the same truck with a 1994 4x4 Toyota Pickup, V6 Master Cylinder. Everything bolted right up. But, I have no play in the brake pedal at all. I think I need to adjust the push rod coming out of the booster into the Master. Is my thinking correct here, or will it not work at all? :confused:
 
Last edited:
pushrod changes are common....loosen the 4 nuts holding the master to the booster, about 1/2 turn each...repeat if the master slowly pushes away from the booster, and that'll give you an idea of how much of the rod to trim off....it shouldn't be much, and once you shave it a bit, you obviously can't get it back ;) May take a few times to get er just right.

Do your brakes progressively "pump up" as you drive, ie, pedal seems to get higher at every stop til finally they are just locked tight?? This is a "sure" sign...
 
I have a 79 Booster with the same MC and it works fine without any mods, but I don't know if the booster is different. Not sure if that helps at all.

Listen to woody
 
The rod coming out of the booster is adjustable. There is a spec for the distance, but almost touching has worked for me. Use a bit of modeling clay on the end of the rod and slide the master in, then remove and look at the clay to see how much it has or hasn't depress. In your case it may be completely flat. Back the end of the rod off untill there is just a tiny bit of clearance. Generaly every time a master is replaced the clearance should be checked.
 
Boy, that was a quick response Woody! I just finished the mod about an hour ago. Drove around the block a couple of times and the brakes work great if I don't throw myself and the dogs throught he windshield when I first stepped on the pedal. I will try adjusting the pushrod tomorrow after work. I will say one thing though, that new master cylinder sure looks better than that old one. And, it was only $65 at the zone.
 
Next question is, anyone know how to wire the 94 master to work with the LC brake warning light? It is a two pin connector so I guess it means power/ground? Just run my stock wire to the master and provide a ground on the other pin?
 
Back
Top Bottom