I'm rebuilding my front and turns out my discs are under the limit (quite a bit actually) and the wheel bearings have some marking on them so I'll replace them too.
Now for putting the new bearings in (wheel and knuckle) I'm going to make a little tool but can anyone tell me the OD of the wheel bearings ? (inner and outer)
Might actually freeze the outer races and warm up the hbu where they go in to to fit them easy but I guess it's good to make a little tool to make sure I can press them in straight and easy.
I can find the bearings here but no info on the OD of the outer races pressed in the hub...
PS.. knuckles were filled with soup so it was a good thing to do before anything went wrong.
Now for putting the new bearings in (wheel and knuckle) I'm going to make a little tool but can anyone tell me the OD of the wheel bearings ? (inner and outer)
Might actually freeze the outer races and warm up the hbu where they go in to to fit them easy but I guess it's good to make a little tool to make sure I can press them in straight and easy.
I can find the bearings here but no info on the OD of the outer races pressed in the hub...
PS.. knuckles were filled with soup so it was a good thing to do before anything went wrong.