What is this?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 19, 2017
Threads
39
Messages
114
Location
Great Barrington, MA
DC968E5D-86F4-462A-8DA0-4A88AB5FD418.webp
55080EB7-02EB-414C-9F13-6DF0CD719C83.webp
I was replacing my valve cover gasket and found this port that is unplugged next to this sensor. And found this hose that comes out the bottom of upper intake and can’t find where in God’s name it goes to..... any ideas? Thanks in advance
 
If you are supposed to be running the stock arrangement the top fitting is for a vacuum hose that should connect to the EGR valve. Underneath the intake the hose should run to the vsv valve. These are part of the EGR system and if aren't fully functional will trigger a p0401 (depending on year or odb version) or related codes and check engine light.

Has the EGR system been intentionally removed/disabled in part? Do you need to pass emissions inspections?
 
Thanks pool! No the egr was replaced with a new oem one to solve a cel issue. The truck is new to me and it’s had countless codes pop and have been slowly getting rid of them..... oh and it’s 97 fzj... I still am confused as to where thes go because my egr has three ports already all being used and the vsv as well
 
They may have bypassed the little metal tube/port that passes through the intake manifold. That port often gets clogged up on high mile rigs and needs to be cleaned out. Now that you have more access you can remove the lower vacuum hose (that's not connected to anything) and clean out that little port using a small drill bit that matches the inner diameter of it.

I can go take a picture of my '97 hose routing later but there is a diagram under the hood and also should be plenty of pictures online of how it should be routed. It's not a big deal if you leave it connected via a hose bypassing the port but it may be cleaner to go back to the stock routing after the pipe/port through the upper intake is cleaned out.

Hope that helps,
 
One other thought,

They may have relocated your VSV valve out from under the upper intake as well. More pictures of your setup would enable folks here to help you understand your setup.
 
Thanks jpoole! Ok I think I may have figured it out. I just need confirmation. The vsv was in fact relocated... and looking at the vacuum diagram it is connected correctly... I’m assuming that nipple on top and the hose underneath the intake is, what I’m going to call, a “manifold through tube”. Meaning there’s a tube that runs through the intake... so, correct me if I’m wrong anyone with this setup could bypass this “manifold through tube” and connect the egr to the vsv. So leaving that “manifold through tube” abandoned should not effect vacuum as long as the egr is connected to the vsv directly. Am I correct? Thanks again
 
Back
Top Bottom