what else do i need for lift?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 28, 2006
Threads
567
Messages
2,693
Location
Charleston, SC
I just bought my first land cruiser. HIP HIP HOORAY!!! It is and HDJ81V, 1HD-T, H442F, AWD transfer case.
I just ordered a set of 4" OME springs and shocks, and a caster kit from a guy in dallas.

My question is-what else do I need to make this setup functional. I am on a budget.
 
I suppose functional depends on intended use. Front swaybar drop brackets to avoid driveline rubbing/hits would be on my list and extended brake lines (frame to axle) if you plan an utilizing all of the suspension droop would be my next suggestion. Would run maybe $150 here in the States regarding budget for both.
 
If you have driveline vibrations, after you put on the lift, you will need a front Double Cardan driveshaft also.
You can't just slap on a set of 4" springs and appropriate shocks and be done with it.

Here's a list from the slee off road's kit.


1 x Slee Front Caster Plate Kit
1 x Double Cardan drive shaft.
1 x Front Sway-bar Drop Kit
1 x Rear Sway-bar Drop it
1 x Front 2" Bump Stop Drop Blocks
1 x Rear 2" Bump Stop Drop Blocks
1 x Set Stainless Steel Extended Brake Lines
1 x Front Panhard Rod
1 x Rear Panhard Rod
1 x Set Adjustable Rear Upper Control Arms.
2 x Breather Extensions
1 x Emergency Brake Cable drop bracket

Most of these items are there for a reason. When you go above 2.5"-3", there's a good chance all of these chassis components need to be addressed.


If so equipped, you will also need to adjust your LSPV. (FREE)
 
LSPV = load sensing proportioning valve. When you lift your truck, this valve needs to be adjusted in order to continue to apply the rear brakes the same way that it did when stock. Moral of the story is this lspv senses the load you have based on what you're hauling or possibly towing, and changes the braking as a result to be more effective.
 
Back
Top Bottom