Welding Mounting Plate for PS

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 6, 2003
Threads
43
Messages
133
I've read through all the tech links and looked at all the pictures I can get my hands on. My question is when welding the plate for the PS box (Saginaw) to the frame, do i first cut out the existing plate that's on the inside of the frame? I guess I could weld the new plate right over it, but I'm affraid of water getting in there over time and rusting from the inside out.

Some of the pictures look like the plate is acutally resesed into the frame. Like a 1/2" grove was cut out of the frame first... Is that what I saw or am I not seeing things right? If it is, is there any significant reason (i.e. alignment with the column)?

Also while I'm at it, I've been shopping around for the box. I got an email from carsteering.com and the guy said that the 800 4.25 turn boxes only have three mounting bolts...? That doesn't make sense to me. He said that they've done a lot of CJ conversions but used the 4 bolt older version. I asked him to clarrify because it's my understanding that there's a 4 bolt, 4.25 turn box floating around out there with my name on it.

Thanks,
Mike
 
skiakhokie said:
My question is when welding the plate for the PS box (Saginaw) to the frame, do i first cut out the existing plate that's on the inside of the frame?



Yes.


Good luck!


-Steve



ShopKam11-30-03-01.jpg
 
thanks, that helps, just out of curiosity, what's the big hole for?
 
skiakhokie said:
thanks, that helps, just out of curiosity, what's the big hole for?


So that you can still get to the nuts on the inside of the frame for mounting the tow hook.


Good luck!

-Steve
 
not sure what kind of welding experience you have, so heres my 2 cents about welding it. Go slow, with small runs. Dont get the plate too hot or it will warp. In the pic above, the bottom half will have a tendency to bend to the side the weld is on, and your box will be harder to bolt on.
Don't ask why I know. :D

-Dustin
 
Depends on the style of plate, mine just laid against the frame rails and lap welded to it. I had to cut inot the top portion of the crossmember rather than a clean hole through it.
 
Also, be sure to sleeve the frame cross member where indicated.
 
what's sleeve? I know I have to cut the hole... but does sleve mean weld a tube in there?

As far as the welding, I'm not doing it. My boss is. He's a fairly experienced welder. He'll probably use a TIG setup. I used 1/2" plate, and with his experience I don't think the warping will be a problem.

Thanks for the heads up though.
 
pics look good fellas,

i'll be doin the same shortly when i switch frames....i'll post up pics when/if i get it done, ha ha

(i like y'all's setups a lot better than the ghetto fab a PO did on mine, i didn't know it could look clean like that, ha ha)

malphrus
 
a quick question....

on the two pics above, one has the bracket/plate extendin on the bottom side of the frame rail, and the other on the top side. is there any extra benefit to either option?


malphrus
 
how much was the kit?
i can't find it on decker's website and that's a long distance call...


malphrus
 
Back
Top Bottom