Water Pump Bolts

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Mr. Toad

20 Year 15 Year 10 Year
Joined
Feb 7, 2005
Threads
63
Messages
1,643
Do the ends of the water pump bolts poke into the engine block's water jacket? The engine's a 1975 2F.

Curious because the threads were furry and brown when I removed them. And I'm asking because if they don't go into the water jacket, then I'm not going to rtv the gasket around the bolt holes.
 
Last edited:
No they do not, just put the blue death around the water hole, anti-seeze the bolts, and be done with it.


Good luck!


-Steve
 
Steve, why do you call it "blue death"?


And I like your pics. Your truck? Cause its red and all.



Ed
 
Thanks for the info. I like to use as little RTV as possible. Makes the next job a little easier.

LC_Hamma -- The brown fur is prolly rusted shavings from rethreading or crossthreading or .......Brown fur are you serious?

Yeah. Given the info from you and Steve C., my theory is that the fur is coolant/rust-stained, powdered, electrolysis deposits. The pump housing is aluminum (I'm pretty sure) and everything else isn't, and the battery ground attaches to the engine very near to the pump (if that matters).

Here's a photo. The grey chalky stuff is the dried out brownish moist fur that was on there when I removed it.
Fur1.webp
 
Last edited:
Insteaad of the "blue death" I use this stuff called "triple bond" available at the local motorcycle store. It's made in Japan and it will seal just about anything with a very thin layer. It's easy to take apart in the future, will fill small minor imperfections, and is easy to work with. That's what I plan to use when I do a thermostat or water pump. As Shawn mentioned, less fuss later when it's time to do the job again.
 
Back
Top Bottom