Hi,
I've replaced the Thermistor with a 10K NTC 25C. (old issue was that it kept freezing, even when temperature had been reached)
Now with the new NTC, compressor stopped at ec 10C (Set to 10C)
But the temperature in the display keeps lowering. At about 3C the compressor starts again.
Does anyone know if it's possible to somehow adjust this?
I guess this must be due to the thermistor not being 100% correct. I was told that Waeco use a 10K NTC 25C, and this is what I have used...
Any suggestion are most welcome
)
I've replaced the Thermistor with a 10K NTC 25C. (old issue was that it kept freezing, even when temperature had been reached)
Now with the new NTC, compressor stopped at ec 10C (Set to 10C)
But the temperature in the display keeps lowering. At about 3C the compressor starts again.
Does anyone know if it's possible to somehow adjust this?
I guess this must be due to the thermistor not being 100% correct. I was told that Waeco use a 10K NTC 25C, and this is what I have used...
Any suggestion are most welcome
)