Vortec Fuel Pump

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 26, 2006
Threads
3
Messages
77
Location
Salty City
Ran a search 'cause I thought I'd run across this information reading threads, but had no hits. First, have you folks who have done Vortec conversions on their FJ 40s found any in-line pumps that work well? Second, has anyone found a good, high quality pump for less than $100? Thought I found a link to a pump that listed for $40-50.

I was going to remove the stock tank (I've never liked having a tank 18" away) and only use the MAF auxilliary. Talked to my builder and we decided to go with the redundancy of plumbing both tanks and having 2 pumps. So, I'd like to keep the cost of the pumps down a bit.
 
Master E2000, should be a stock item at most any autodroid store....60psi, IIRC

Master E8153 for a TBI, IIRC (I run this one...)
 
E2000 is the correct pump to support 65 PSI requirement. Don't go cheap! You will only need one H.P. pump. You can use a lower volume and less expensive pump to feed the main tank.
 
Thanks all for the information. I had looked up pumps at Howell, Edelbrock, etc. and was in sticker shock at the prices.
 
Not to hijack, but....speaking of Vortec fuel pumps....I think the pump in the back has gone out on my '98 Yukon. It has been kinda moaning or singing for a while and now makes no noise when the ignition is switched on and the truck will not start.
Is this pump in the tank? I know the filter is not in the tank as with some.

And is there any way to get the thing to run the few short blocks to the repair shop? Like if I can get it started, will it continue to run, or should I just call the tow truck?

Thanks

Ed
 
I just bought a E2000 for $116 and a lifetime warranty from a local supplier. The maker of the pump was AIRTEX, seems like a nice quality part. Do you know the size of the fittings coming out of the motor (supply and return). I know the tube sizes but trying to figure out the fitting sizes.

Cheers
 
Airtex

Sorry, don't know any fitting sizes.

I called Airtex and the tech support guy gave me a "kit" number that includes a pump with specs similar to the E2000, brackets and fittings. So this may simplify my install. Left my notes at work, so I won't guess at it.

My local Autozone has the E2000, so I will call tommorow to find out if they also have the "kit". Don't know how similar the pump will be or I'd offer to post info on the fittings.
 
HogDriver said:
I just bought a E2000 for $116 and a lifetime warranty from a local supplier. The maker of the pump was AIRTEX, seems like a nice quality part. Do you know the size of the fittings coming out of the motor (supply and return). I know the tube sizes but trying to figure out the fitting sizes.

Cheers


post up a couple pics bud...
 
Back
Top Bottom