Very low idle only when warm?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 28, 2006
Threads
101
Messages
594
Location
Leesport, PA
My 94 has recently developed all kinds of annoyances. After it is good and warm on a longer drive, it will barely idle in or out of gear at idle. Runs fine, and normal idle stands around 550 RPM. When it will barely idle it's down around 300 RPM. My throttle body has been cleaned recently, and the air intake tube checked for cracks. What else should I look for? I searched but couldn't find much that made sense, one person recommended PCV but I wasn't understanding the correlation. I was thinking possibly IAC valve, but why would it only do it when hot? Also, throttle cable came up, but it doesnt appear that would cause a low idle? Any suggestions, hopefully I'm missing something easy here.
 
bumpin.. no ideas???
In my case swapping PCV and cracked hose for PCV <> Intake
solved my low idle, amazing enough high idle at startup is not that high anymore either. Thats all I did.
:hhmm:
 
I will check the EGR and pull the PCV, check to see if the ball inside still moves... thanks for the suggestions. Out of curiosity, is there an easy way to bump up the idle, like and idle adjustment screw perhaps?
 
I will check the EGR and pull the PCV, check to see if the ball inside still moves... thanks for the suggestions. Out of curiosity, is there an easy way to bump up the idle, like and idle adjustment screw perhaps?
I would say replace PCV first and make sure hose is sealed around PCV and intake. I did test it , mine looked sort of fine but it was letting little more air then it supposed to. Just replace and put new hose on it. Total cost is $10

EDIT: Dont touch adjustment screw unless you are prepared to spend some time to get your idle back
 
Not sure what idle adjust screw you guys are talking. On mine, the "idle adjust screw" only has an effect when the engine is being started, once the engine is running, the vac pulls the thing back out the way, leaving you on IAC.
 
Look for vacuum leaks, especially on the big air tube from the air cleaner. You may then want to make sure the Throttle Position Sensor is reading correctly. If all is good, check timing. If all this is good, Use your FSM to check out the IAC to see if it is working. The IAC controls the idle on your truck. You would have to pry off a cap to find the throttle adjustment screw, this should not be necessary if all is working correctly.
 
Back
Top Bottom