Valve cover half moons

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 22, 2005
Threads
44
Messages
482
Location
Misery's feed trough
I'm replacing my valve cover gasket. I'm going to remove the half moon covers in the front and re-seal them also. Are they just pressed in? I don't want to mess them up prying them out.

Also, am I OK to use red FIPG on them?

Thanks in advance.
 
I'll ask a stupid question I guess: what is the purpose of the half moons and why would I want to push them out and then reseat them?

I am about to replace my valve cover gasket, so I'll be there anyway. Which is why I'm curious. :hhmm:
 
I'll ask a stupid question I guess: what is the purpose of the half moons and why would I want to push them out and then reseat them?

I am about to replace my valve cover gasket, so I'll be there anyway. Which is why I'm curious. :hhmm:

they will potentially leak from that spot and you will have to do the job all over again.
 
Mine were already leaking there. Just yank them straight up with pliers and they will come out. Don't forget to buy spark plug gaskets. Mine broke when taking the cover off (as many posts said they would). They were hard as a rock along with the VC gasket.
 
The red FIPG is **technically** not the correct one to use. The red is for diffs/tranny pan.

The gray/black FIPG is what you need.

That said, I do not know what the differing properties are between the two, so I do not know why they are not interchangeable. CDan might be a good person to ask...or any Toyota mechanic.

Good luck.
-o-
 
Mine were already leaking there. Just yank them straight up with pliers and they will come out. Don't forget to buy spark plug gaskets. Mine broke when taking the cover off (as many posts said they would). They were hard as a rock along with the VC gasket.

Looks like I'll be buying some black/grey FIPG (though I don't even know what that stands for).

CDAN took care of me on the spark plug gaskets. I just told him what I wanted to do and he told me what I needed and talked me out of buying stuff I didn't need (and all this while he was trying to leave for TX last night!). But that is why I love ordering from CDAN and I do not order from any other place.

:beer:
 
When I did my HG I used the red fipg as I was hoping it would look cool as part of the Toyota red theme. It has held up well so far but only have 800 miles on her after the rebuild. If I did it again, I would use the grey.

Buck Buchanan
 
FIPG = Form in Place Gasket

I think you can use the stuff instead of an actual gasket (that's what Cdan told me) but i bought mine to help me install my gaskets (from sliding around).
 
I'll ask a stupid question I guess: what is the purpose of the half moons and why would I want to push them out and then reseat them?

I am about to replace my valve cover gasket, so I'll be there anyway. Which is why I'm curious. :hhmm:

The half moons fill in the machined-out portions of the timing chain cover that allow you to remove the bolts that hold the timing gears to the cams.

David Sword
 
FWIW, when you replace the valve cover gasket it is also I good time to replace the PCV valve on the cover..The rubber grommet gets hard and cracks when R&R with the valve cover on..Sometimes these little pieces fall into the valve cover, it is a lot easier to take out these pieces with the valve cover off...
 
Back
Top Bottom