Valve Clearance Check - Thoughts?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 14, 2007
Threads
79
Messages
587
Location
Sacramento, CA
Just checked the clearances on my new-to-me '96 LX-450. 160,000 on the truck, entire head assembly was replaced under warranty at ~65,000 miles, and I'm fairly sure the valves haven't been checked since. These are what I measured, in thousandths:

Intake Exhaust

5 12
6 12
8 14
9 13
8 15
8 13
7 13
8 13
9 15
8 14
7 13
7 13

Those are listed starting with the #1 cylinder and going back towards the rear of the truck. FSM specs are .006-.010 for the intake and .010-.014 for the exhaust.

Would you guys recommend messing with these to get them more towards the middle of the spec range? Or do they look close enough? If not, I'll be picking up a micrometer tonight and having some fun pulling the cams off...

Thanks,
Desmond
 
Leave those alone. It's better to be a bit loose as opposed to too tight, and some of the shims are made of unobtanium. Hardly worth the effort for two valves that are .001 out of spec. If you do decide to do it, there's a tool that will pull all but the #6 shims without removing the cams. When I did my head gasket, I had the valves ground and had a hard time coming up with all of the appropriate shims. It's back together with 2 valves out of spec loose and it runs perfect. I wish I had just put it all back together without doing the valve grind.
 
Leave those alone. It's better to be a bit loose as opposed to too tight, and some of the shims are made of unobtanium. Hardly worth the effort for two valves that are .001 out of spec. If you do decide to do it, there's a tool that will pull all but the #6 shims without removing the cams. When I did my head gasket, I had the valves ground and had a hard time coming up with all of the appropriate shims. It's back together with 2 valves out of spec loose and it runs perfect. I wish I had just put it all back together without doing the valve grind.


Thanks, that's what I was hoping to hear! Any other experts want to chime in on this before I start buttoning it back up?
 
kind of funny that we have an engine that adjusting the valves after 200,000 miles is not necessary and frankly, not worth the hassle.
 
Back
Top Bottom