vacuum

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 14, 2005
Threads
70
Messages
1,157
Location
Glendale CA
how dose vacuum work and were dose it come from. I just put a new ENG in a 75 2F with an RV cam my compression psi is 115 on all 6 Cly. my vacuum psi is 10. It runs ruff and mises at all rpm,s and seems to run hotter then it did be for. it has about 30 min of run time.
 
First, Vacuum is usually in "Hg or inches of mercury...... it is negative pressure
A vacuum leak can cause all of those symptoms. The engine vacuum is generated by the intake stroke pulling air through the nearly close butterfries in your carburator while idleing. Tha anount of vacuum you get is dependent on a lot of things (RPM, throttle position, load, etc....)
A vacuum leak can be located where the intake manifold seals to either the head or the carburator..... or a disconected vacuum line..... or a bad brake booster....... or a bad front drive diagphram..... or..... well, you should get the idea by now. :)
PMK

calico kid said:
how dose vacuum work and were dose it come from. I just put a new ENG in a 75 2F with an RV cam my compression psi is 115 on all 6 Cly. my vacuum psi is 10. It runs ruff and mises at all rpm,s and seems to run hotter then it did be for. it has about 30 min of run time.
 
this 2f has flat tops and open chambers how will this effect how the motor runs.
 
Back
Top Bottom