Using Solar Controller Load Output with a Fridge

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Dissent

Questioning my life choices...
GOLD Star
Joined
Sep 27, 2012
Threads
271
Messages
3,822
Location
Sweetwater, TN (SW of Knoxville)
I have a Morningstar Prostar 30M solar controller and a single battery. I found the Load Output handles 30A. An ARB fridge requires a dedicated 15A circuit. Could I run the fridge off the Load Output to take advantage of the Low Voltage Disconnect or just leave it on the battery and use the LVD for lights and USB ports as the fridge has a built in LVD cutoff? What are you guys doing?
 
ARB fridge will draw maybe up to 5A max when starting, less while running. The ARB also has a cutoff and you can adjust it via the front panel that works fine. The ARB 15A circuit is more likely mentioned to ensure you have nice gauge wires from the fridge to the battery to minimise voltage drop.

With a controller that can log watt.hours (like the victron unit we've discussed in the power system subforum) then connecting to the solar controller's load output makes sense if you're interested in daily power use (versus input solar power input).

cheers,
george.
 
Great, thanks for the input. I'm going to run this setup for awhile and lean on the LVD and my Jump Pack as insurance until it proves me wrong.
 
Similar set-up.
But fridge is connected to the ProStar, I'd consider a two (or 3) way switch to have the ability to power it up either from the car battery when moving and switching to the PV battery when sedentary (camping). I have my switch in the rear near the fridge, it takes a split second to switch to the PV when stopped while unpacking. On the road, I set the fridge to max, and when I arrive everything is really cold & frozen remain frozen, then I set the fridge to normal cooling, PV battery isn't even used for like a day+.
DSCF3891.webp
 
Back
Top Bottom