Upgrading Steering arm bracket

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 5, 2005
Threads
223
Messages
8,831
Location
NC
Anyone out there know if we can upgrade our earlier model steering arm bracket to one from a later model ? (ie I have a 64 fj and have the entire set up from a 74 fj that i would like to throw in there ). Reason for all this is it is easier to get the parts for the later model one as in the center shaft that goes down the middle. Mine is all buggered up on the threads from the PO, and have not had any luck finding any new ones.

Thanks much.
 
If you are talking about the center arm, I did just that on mine('66). Only problem is that the front crossmember is at a different angle on the early ones.
I used a piece of heavy walled angle and boxed part of the frame horn.


Ed


Hope this is what you are talking about....udderwise I feel like an ass:o

Good Luck
dogs 006.webp
dogs 007.webp
 
Back
Top Bottom